Hi all, long time no visit.
Daughter still has her 2008 1.2 Pop, which has been behaving itself, other than needing a new Battery last year, and the usual servicing, Bulbs, Tyres etc.
Now it's showing various Warning Lights.
Airbag
Eng Fault Light
Triangle of Doom
It's also been giving a Low Brake Fluid Warning, despite the Level being fine.
I've check for Codes using my Topdon Diagnostic Unit.
It's showing;
P0504-67 Brake Pedal Switch - Signal Incorrect After Event. Brake Lights go on/off as expected, and the Fault did Clear.
C1215-29 Brake Light Switch - Signal Signal Invalid (yes, it says Signal twice)
U0422-81 FPS Strategy Not Valid Data From BCM - Invalid Serial Data Received
Does the Brake Switch have two lots of contacts, or are there two Switches (Brake Pedal, and Brake Light)?
I've done a fair bit of searching, the only Code list I found doesn't list the U0422-81 or P0504-67 Codes.
Only the C1215-67 ~ Brake Light Switch - Invalid Signal - Anti-Lock Brake System (ABS) Module detects that the Brake Lamp Switch is sending an internal failure message.
Searching seems to point mostly to the Body Control Module (BCM), are they generic to the 500s, i.e. can I just replace with another used one, or is there some sort of Programming/Flashing required?
Any ideas?
Thanks all . . .
Daughter still has her 2008 1.2 Pop, which has been behaving itself, other than needing a new Battery last year, and the usual servicing, Bulbs, Tyres etc.
Now it's showing various Warning Lights.
Airbag
Eng Fault Light
Triangle of Doom
It's also been giving a Low Brake Fluid Warning, despite the Level being fine.
I've check for Codes using my Topdon Diagnostic Unit.
It's showing;
P0504-67 Brake Pedal Switch - Signal Incorrect After Event. Brake Lights go on/off as expected, and the Fault did Clear.
C1215-29 Brake Light Switch - Signal Signal Invalid (yes, it says Signal twice)
U0422-81 FPS Strategy Not Valid Data From BCM - Invalid Serial Data Received
Does the Brake Switch have two lots of contacts, or are there two Switches (Brake Pedal, and Brake Light)?
I've done a fair bit of searching, the only Code list I found doesn't list the U0422-81 or P0504-67 Codes.
Only the C1215-67 ~ Brake Light Switch - Invalid Signal - Anti-Lock Brake System (ABS) Module detects that the Brake Lamp Switch is sending an internal failure message.
Searching seems to point mostly to the Body Control Module (BCM), are they generic to the 500s, i.e. can I just replace with another used one, or is there some sort of Programming/Flashing required?
Any ideas?
Thanks all . . .