Guides by Panda Nut

Believe me this is going to be easier than reading Fiat's instructions. The setting up section is unintelligible, so I ignored that. I shall cover it it with either an ammendment or subsequent guide as I fitted my sensors and they worked striaight out of the box. This guide applies to various...

The big breather hose is the thin one, from under the air box, to the base of the plastic inlet manifold. It provides vaccum to extract fumes from the crank case. This one is goosed. I find the standard hose a bit short, to the extent it pulls off when you touch the air box, and is not long...

Guide: Panda 169 Fitting and wiring fog lamps using accessory switch and independent relay Difficulty 3 / 4 Soldering required Time to do ½ a day Panda 169 without fog lamps can be fitted quite easily. Tools and materials required. Large flat screwdriver / pry tool and a thick cloth or...

Tools Required Philips screwdriver Fine and standard pliers Torx bits 10mm spanner 1/4inch drive socket set 8mm and 10mm Mini cutting discs (Dremel type) Torque wrench for wheels bolts Instructions Jack up the side affected and support car with axle stand(s) Remove the road wheel Undo the...