Guides by chris3234

you will need a selection of torx bits for this start by folding the rear seats down then remove the covers from the rear seat back mounts next remove the two lug holding to boot carpet in place they should screw out then you can remove the two bolts holding the rear seat bases in place...

Quick guide with a few pictures on taking front door trims off first take the two cover trims off the latch side od the trim panel off there will be two Philips head screws underneath remove them both the take the rubber bottom out of the door handle area and there will be a hex head bolt...

Tools needed basic socket set and a 16mm spark plug socket with long extension start by removing the two 10mm bolts either side of the airbox then remove the bolt under the air inlet pipe (see pic 1) next remove the bolts holding the coil pack conector rail and the Earth conection for them...