Technical Panda 169 Driver airbag lamps

[atakan123123]

Hello. I haven't seen any problems with the wiring yet.

When I hit the front fuse panel with my hand, the fault light goes off.

When it goes off, it turns on the passenger lamp first. He then extinguishes them both.

I have yet to discover a fault in the wiring. But does he have a known chronic problem? Like sockets darkening?

 

[koalar]

Probably just the passenger airbag switch in the glove box

Try turning the key from on to off and see if the fault changed

The switch pops out from the front there's no need to undo any screws

 

[atakan123123]

Isn't the passenger airbag button marked yellow on the dashboard?
Isn't that the red driver's airbag?

The passenger key works pretty well. When I turn it, the yellow light comes on. When I call again it is disabled.

I took my first night drive with my car. The red light turns on and off slightly as you go over bumps. I think there is a lack of contact, I will check the sockets and cables again.

 

[koalar]

Yes

But there is a resistor for passenger airbag on and a different resistor for airbag off, if the system detects open or short circuit the red light will come on

 

[atakan123123]

Yes

But there is a resistor for passenger airbag on and a different resistor for airbag off, if the system detects open or short circuit the red light will come on

When I punch the fuse panel a little, the fault lights go off. It may then light up again after a pothole or crash.

When I connected it to OBD before. It gave the passenger airbag fault code.
Maybe it's like you said.

What should I do in this situation? I can turn the key. Or I can remove its socket.

Since you said the resistors are different. There would be no point in canceling the switch by turning it completely to the short-circuit position.

 

[koalar]

Back of the switch

Not my photo

If one resistor is loose it likely the other would be fine


The switch comes out from the front, no need to undo any screws


Punto ones are the same

 

[atakan123123]

Back of the switch

Not my photo

View attachment 432512

If one resistor is loose it likely the other would be fine


The switch comes out from the front, no need to undo any screws


Punto ones are the same

This is more than enough for me I will check it out thank you!

 

[atakan123123]

I detected the problem.

Messy electrical wiring was putting pressure on the fuse holders.

I started organizing the electrical installation. I moved the fuse slightly. There have been no problems for a long time.