Hi all,
I know this has been covered before, and I've read the multiple threads in the Panda and 500 sections covering the same issue, however nobody actually addresses root cause in my opinion, so intend to try and get to the bottom of the issue based on previous experience.
Firstly as has been mentioned, steaming up of the inside of the windows occurs as a result of the inside of the car not being able to breathe (no outside air entering the cabin). This can be mitigated by using the AC to act as a dehumidifier (if your car has AC), or open your windows a little bit. Both are unfortunately only a temp fix and do not address the root cause. I wont even entertain the other suggestions lol
So we know that the recirculation button should be in the "OFF" position, to allow fresh air to enter the cabin, but what happens when it is off and the windows are still misting up? :idea:
More importantly, when the recirculation button is switched on, what mechanical part does this action send a command to and where is it located in the vehicle?
In my experience with an old Alfa, there was a flap hidden under the dash that had a mechanical actuator so when the recirc. button was pressed it would either open, or close, dependant on state. In my case it was permanently closed regardless of what the sate the button was in, which of course meant an actuator mechanical fault or electrical. Long story short, no new parts could be bought due to the age of the car so a firm press with the hand left the flap in the permanently opened position
.........and........no steamed up windows since no matter what the weather without even needing to use air con.
So to the point, does anybody know where the recirculation control flap is located in the GP? Is it easy to get to and which part of the car needs to be disassembled inside/outside?
Any specific feedback to the question will be appreciated.
My GP currently needs the wipers on the inside more than it does on the outside
and needs sorting sharpish, or I need to invest in a kitchen towel company lol.
Hum
I know this has been covered before, and I've read the multiple threads in the Panda and 500 sections covering the same issue, however nobody actually addresses root cause in my opinion, so intend to try and get to the bottom of the issue based on previous experience.
Firstly as has been mentioned, steaming up of the inside of the windows occurs as a result of the inside of the car not being able to breathe (no outside air entering the cabin). This can be mitigated by using the AC to act as a dehumidifier (if your car has AC), or open your windows a little bit. Both are unfortunately only a temp fix and do not address the root cause. I wont even entertain the other suggestions lol
So we know that the recirculation button should be in the "OFF" position, to allow fresh air to enter the cabin, but what happens when it is off and the windows are still misting up? :idea:
More importantly, when the recirculation button is switched on, what mechanical part does this action send a command to and where is it located in the vehicle?
In my experience with an old Alfa, there was a flap hidden under the dash that had a mechanical actuator so when the recirc. button was pressed it would either open, or close, dependant on state. In my case it was permanently closed regardless of what the sate the button was in, which of course meant an actuator mechanical fault or electrical. Long story short, no new parts could be bought due to the age of the car so a firm press with the hand left the flap in the permanently opened position
So to the point, does anybody know where the recirculation control flap is located in the GP? Is it easy to get to and which part of the car needs to be disassembled inside/outside?
Any specific feedback to the question will be appreciated.
My GP currently needs the wipers on the inside more than it does on the outside
Hum