T TSAF Member Joined Jun 12, 2008 Messages 65 Points 67 Dec 7, 2015 #1 Has anybody changed or repaired the sender unit(float) in the barchetta.? After a pump change it does not work.
Has anybody changed or repaired the sender unit(float) in the barchetta.? After a pump change it does not work.
HP I was only doing 80... Parked in the garage Written a guide Joined Mar 22, 2002 Messages 13,429 Points 2,034 Location North East Dec 8, 2015 #2 Check the electrical connections are ok and the float/arm isn't jamming. Also try shorting out the sender to see if the fuel gauge goes to 'full'.
Check the electrical connections are ok and the float/arm isn't jamming. Also try shorting out the sender to see if the fuel gauge goes to 'full'.
OP OP T TSAF Member Joined Jun 12, 2008 Messages 65 Points 67 Dec 8, 2015 #3 Finally, it was not properly placed, and it was stuck on side of the tank. For future reference, I meausure it and the range was 005-305 ohms. Last edited: Dec 8, 2015
Finally, it was not properly placed, and it was stuck on side of the tank. For future reference, I meausure it and the range was 005-305 ohms.