Last week my 2014 panda twin air clutch slave cylinder started screeching and squealing. Gears were hard to select, clutch pedal didn’t seem to want to come up. Had a job to make it home. At least I thought it was the slave cylinder after doing my research including on here.
So, I changed it this morning, not too hard a job. Now it drives as normal, changes gear ok, no clutch slip evident, clutch feels pretty normal as far as I can tell, but……. It still screeches like f***. It’s silent when the clutch is fully up and on the move. But stationary it can either be almost silent, or screechy. Depressing the clutch up and down is always screechy.
I’m a bit baffled now
(Note: I posted this in the wrong forum (mk 3, link below) under a different title when it seemed like a slave cyclinder problem but now seems more like a release bearing problem. My latest reply on that thread is below.
Quote Reply
Report
So, I changed it this morning, not too hard a job. Now it drives as normal, changes gear ok, no clutch slip evident, clutch feels pretty normal as far as I can tell, but……. It still screeches like f***. It’s silent when the clutch is fully up and on the move. But stationary it can either be almost silent, or screechy. Depressing the clutch up and down is always screechy.
I’m a bit baffled now
(Note: I posted this in the wrong forum (mk 3, link below) under a different title when it seemed like a slave cyclinder problem but now seems more like a release bearing problem. My latest reply on that thread is below.
Panda Slave Cylinder? | FIAT Panda (Mk3)
Last week my 2014 panda twin air clutch slave cylinder started screeching and squealing. Gears were hard to select, clutch pedal didn’t seem to want to come up. Had a job to make it home. At least I thought it was the slave cylinder after doing my research including on here. So, I changed it...
www.fiatforum.com
Quote Reply
Report
Last edited: