I was just wondering about the tyre pressures on the front tyres on the 100hp as I usually put them at 2.2bar but they always looks a bit too soft. What pressures does everyone else put them at?
Technical 100HP Tyre Pressures
- Thread starter W23AJH 100HP
- Start date
Currently reading:
Technical 100HP Tyre Pressures
32psi all round.
I'm with Lauren - 32 PSi front and rear 
I do what the book says. 2.2 front, 2.1 rear.
OP
OP
Cheers, don't you find that the fronts always look a bit on the soft side to you?
That can depend on the stiffness of the sidewall, always go by what the manufacturer says rather than your eye.
OP
OP
32psi at the front and 30psi at the back for me.
robjnr
Member
- Joined
- Jun 4, 2010
- Messages
- 363
- Points
- 61
Me to.
- Joined
- Sep 12, 2003
- Messages
- 46,059
- Points
- 7,364
So what if it quotes bar, surely you just do the conversion to PSI, not exactly rocket scienceWhere did you get that from? It quotes Bar in the hand book
Anyway, who says the handbook is right, some people like to under-inflate, some like to over-inflate, depends on their driving style and how they like a car to handle.
Where did you get that from? It quotes Bar in the hand book
Simple, converted the high load settings to PSI. Tbh I run 32 in the rear to try and loosen the rear end a tad, though the difference between 30 and 32 in the rears is hard to notice. I think if I took it on track I'd look at inflating the rears to 35 or so.
