The stepper motor is a weak point on some of these engines. This is a very short guide to how it works
- Next page: The stepper motor
Bravo (Classic)/Brava Fiat 1.2 16v Stepper motor
- Author m20b25
- Publish date
- Article read time 1 min read
Table of contents
Guide information
More in FIAT Cars
-
Panda 2012+ Wiper arm removal Panda 319. I have seen a post asking how these scuttle wiper arm covers come off. Most Fiat plastic bits... -
Panda 2012+ Reversing Sensors fitting (Fiat Ricambi Accessori)Believe me this is going to be easier than reading Fiat's instructions. The setting up section...
-
Bravo Front speaker replacementThis is a guide to replace stock front speakers with aftermarket ones, since for many, original...
-
500 Fiat 500 2008-2009 clutch pedal brokenCarried out a repair to clutch pedal on Fiat 500 2009 where it had snapped at the weld...
-
Tipo Fitting a dashcam to the Tipo. A guide.Here I fit a Nextbase dash cam to my Tipo. I have fitted one before, hardwired in my old Volvo...
More from m20b25
-
Bravo (Classic)/Brava Bravo front and rear disk conversions (except HGT)This guide is intended for cars using 257mm 12mm solid discs and drums. Set some time for the... -
Bravo (Classic)/Brava Alfa 146 Handbrake conversionI found that the handbrake in my Bravo was pretty poor so after some trial and error, I found...
-
Bravo (Classic)/Brava Lock Mechanism/ Door handle ChangeAre they serious? Theres a lot more to it than that. I hope this guide helps out anyone in...