Just changed the front discs and pads on my 500 when fairly well bolt's holding the frames the the disc/hub were hard to remove took a fair bit of work with a breaker bar before the moved
Only problem was one of the two locator pins in each side was sized solid strangely 1 each side came off easily
Ended up snapping them clean in two so cut them flush to the disc with an angle grinder and refitted the new discs with just the one good pin
Anyone else had problems with them being sized,?
Only problem was one of the two locator pins in each side was sized solid strangely 1 each side came off easily
Ended up snapping them clean in two so cut them flush to the disc with an angle grinder and refitted the new discs with just the one good pin
Anyone else had problems with them being sized,?