Seamus2012
New member
- Joined
- Apr 5, 2012
- Messages
- 101
- Points
- 26
Thanks for that. Got it sorted now. Found that one of the wires in the VAG plug had disconnected.
I have run the Multiecuscan and am no further forward.
Cleared the codes and no further ones came up.
Went through all the parameters but can't tell if they are normal or now. On the lamda sensor pre cat at idle it switching from lean to rich continually. Managed to capture a screen shot of the first page of the parameters.
Whilst testing I found that once the fan cuts in (ie its hot) then it runs rough and stalls, and is difficult to start again until it has cooled down.
Can someone guide me as to where I go from here please.
I have run the Multiecuscan and am no further forward.
Cleared the codes and no further ones came up.
Went through all the parameters but can't tell if they are normal or now. On the lamda sensor pre cat at idle it switching from lean to rich continually. Managed to capture a screen shot of the first page of the parameters.
Whilst testing I found that once the fan cuts in (ie its hot) then it runs rough and stalls, and is difficult to start again until it has cooled down.
Can someone guide me as to where I go from here please.