Panda 1.1

Currently reading:
Panda 1.1

I would be wanting to test that spark with MES.
Check wiring is plugged in. Remove plug from coils pack(s)and give it a wiggle to see if anything changes because of a broken wire. Look for any corrosion or broken pins.
Maybe try another coil or if you ahve two coil packs swap them and see of this restores the spark. Replace duff coil packs with new.
Good luck
 
Are you sure it's the crankshaft sensor at fault?
It's easy to check if it's working. While cranking, watch the RPM gauge. The needle should rise to 200~300 RPM. If it stays down, means the sensor is bad.
Is the IMMO light on the dash going off in 1-2 sec. after you turn the ignition on?
 
this Panda model does not have an engine speed indicator and an IMMO light.. by turning on the ignition, the fuel pump is heard..
 
Does the oil can light come on at ignition on
Does the battery light come on at ignition on
Does the engine check light come on at ignition on

Do the stay on during cranking
 
Back
Top