TrailerBob
New member
- Joined
- Jun 26, 2014
- Messages
- 8
- Points
- 2
Firstly a very big hi to everyone, this is all very new to me.
Having a horrible squealing sound from my Brava 1.4, which got worse when I pushed the clutch down. I decided to change the clutch, which I did over the last few days, whilst stripping down the clutch I saw a sticky black mess at the end of the slave cylinder, so a new one of them fitted.
While the car was on axle stands I started the engine went through all gears, very gently, and everything seemed fine. Now the car is back on the ground I find that I cannot select any forward gears or reverse.
If I start in first, with the clutch all the way down the car starts but then the biting point is only about 1" up from the floor. I have bled the slave cylinder and there does not seem to be any bubbles in the system, also when the clutch is pressed I can see the slave arm pushing the selector.
Any ideas or help would be greatly appreciated.
Thanks to anyone in advance BOB
Having a horrible squealing sound from my Brava 1.4, which got worse when I pushed the clutch down. I decided to change the clutch, which I did over the last few days, whilst stripping down the clutch I saw a sticky black mess at the end of the slave cylinder, so a new one of them fitted.
While the car was on axle stands I started the engine went through all gears, very gently, and everything seemed fine. Now the car is back on the ground I find that I cannot select any forward gears or reverse.
If I start in first, with the clutch all the way down the car starts but then the biting point is only about 1" up from the floor. I have bled the slave cylinder and there does not seem to be any bubbles in the system, also when the clutch is pressed I can see the slave arm pushing the selector.
Any ideas or help would be greatly appreciated.
Thanks to anyone in advance BOB