General Limp mode

Currently reading:
General Limp mode

Billybilly

Member
Joined
Dec 3, 2023
Messages
30
Points
58
Location
Sunderland
Has anyone had limp mode on punto 1.2 pop and what causes it.my levels are fine ive changed plugs.leads and coil pack plus crankshaft and camshaft sensors and still goes into limp mode sometimes every couple of miles.im loztnow what to do the obd says intermittent mis fire on cylinder 2 and 3.
 
Has anyone had limp mode on punto 1.2 pop and what causes it.my levels are fine ive changed plugs.leads and coil pack plus crankshaft and camshaft sensors and still goes into limp mode sometimes every couple of miles.im loztnow what to do the obd says intermittent mis fire on cylinder 2 and 3.

Does this happen only on faster roads..?

Or just running around town🤔
 
Does this happen only on faster roads..?

Or just running around town🤔
Just around town maybe 40mph
Should rule out the Cambelt change MIL problems then...

Tell us more about the car..

How many months of good running until this?
Since doing service on car and had tofit new pickup pipe in sump as it was broken allowing no oil to the engine
 
0. Something silly (from lack of preventive maintenance).
1. Electrical. Power delivery, battery, alternator, main wiring corrosion both "earth" and "positive", main fuse/relay box.
2. Fuel delivery. Check pressure, take a look at the injectors. Try fuel additive (cleaner).
3. Timing and/or VVT. Check via OBD2, FES or MES program ("VVT1 position" 106 degrees or very close).
4. Electronics (ECU failure, ignition coil drivers), sensors (MAP, temperatures, lambdas and so on).
 
Back
Top