Punto Power 2
New member
- Joined
- Jun 8, 2017
- Messages
- 9
- Points
- 3
My Heater packed in a good while back which was fine as it wasn't cold then. The usual suspect block connector going into the resistor was the problem, I thought it was Seriously burnt out. I cut the connector off to be safe and made sure no wires were touching. Managed to get a new connector today after a little searching but when I connected it up nothing happened I also changed the resistor as the one on it was pretty rusty and I wasn't Sure of its condition. The 30 Amp fuse in the engine fuse box is fine. Bit lost at what to try next, any ideas would be greatly appreciated, many thanks John