Technical Changing the coolant in my Sei

[geppetto2]

Not done this before but I reckon it's time my 2000 SPI Sei's coolant was
changed.
Couple of questions, is the bottom hose easy to get at and get off and
also I'm a bit concerned about the bleed screws breaking.
Is this likely and if so whats a quick repair to get me back on the road?

Cheers guys

 

[fingers99]

Couple of questions, is the bottom hose easy to get at and get off and
also I'm a bit concerned about the bleed screws breaking.
Is this likely and if so whats a quick repair to get me back on the road?

Cheers guys

It's certainly possible to break the bleed screws. I'd see if you can shift them before starting the job so you can either buy another or see how to make one up from a bolt -- never done it, but those who have say it's easy enough with a bolt and a hacksaw.

The hose is easy enough to get at but putting the front end on ramps or axle stands will help. If it has never been done before you'll need to replace the clip with a hose clamp. Sometimes they will stick a little, but gently working away at it will get it off. Remember that it's far cheaper to buy a new hose than a new radiator!

 

[Liam]

Bottom hose = just don't be scared to pull.

Bleed screws = break when you tighten them with tools use your fingers in gloves!

Liam

 

[geppetto2]

Thanks guys