If its a54/60 hp engine.. just fit a new one..
69hp.. interference engine
69hp.. interference engine
03 panda won't restart?
- Thread starter Cozy22
- Start date
Currently reading:
03 panda won't restart?
I was going to suggest a jumped belt.. not that unusual
Is your Antifreeze definitely good.. wondering if a frozen pump caused this?
The bearing failed on my 1108cc and the belt skipped 7 teeth.. retimed it was fine
Still running now.. a decade later
Is your Antifreeze definitely good.. wondering if a frozen pump caused this?
The bearing failed on my 1108cc and the belt skipped 7 teeth.. retimed it was fine
Still running now.. a decade later
Last edited:
03 petrol
Snapped belt
Should be fine with a new belt
Snapped belt
Should be fine with a new belt
- Joined
- Jan 16, 2017
- Messages
- 12
- Points
- 54
How easy is it to reset the timing once the belts been done? It's actually an 04 dynamic 1245cc
Not too bad
Look in Cinq/ sei section GUIDES
And my panda GUIDES should give more pointers.. like the engine mount
Dead easy there’s timing marks on both pulleys
Just be careful to use the correct instructions
There a mistake on one online instruction and other sites have copied and pasted it
Is right
However note the crank shaft pulley is drawn upside down
Just be careful to use the correct instructions
There a mistake on one online instruction and other sites have copied and pasted it
Is right
However note the crank shaft pulley is drawn upside down
Last edited:
