Technical Vauxhall alloys

[Platoon]

Hi guys, I bought some OZ-Sparco alloys, however those are for Vauxhall (4x100) and have an ET 49. Knowing that, what combination of spigots, spacers and wobbly bolts am I going to need? (the alloys are 6Jx14 and I'll mount 185 50 14 tyres.

Thanks a lot in advance!

 

[chaos]

The centre bore is smaller for Vauxhalls - you would have to bore out the wheel centres if safe/practical. If not then you'll have to get a new set of alloys. Spigots are for reducing the centre bore, not increasing it.

 

[Platoon]

I'm practically sure the centres are quite bigger, I'll check it tomorrow anyway!

 

[chaos]

I'm practically sure the centres are quite bigger, I'll check it tomorrow anyway!

A Vauxhall Corsa CB is 56.6mm and the Fiat is 58.1mm according to other sources

 

[beau]

A Vauxhall Corsa CB is 56.6mm and the Fiat is 58.1mm according to other sources

they probably had spigot rings to make the cb smaller though.

 

[Gav F]

i run vauxhall fitment (corsa) Aez dions 14x6
bore is slightly bigger but when i put it on i try to centralise it
have looked into gettin spigots from Aez, but not fussed atm
Just have Wobbly bolts and 5mm spacers all round on mine (althougt spacers not needed!)

 

[chaos]

they probably had spigot rings to make the cb smaller though.

No, standard Vauxhall fitment.