Styling Rear wiper idle position

Currently reading:
Styling Rear wiper idle position

Joined
Nov 21, 2003
Messages
416
Points
113
Location
Lostwithiel, Cornwall
Not sure weather this shud go in styling or technical but here goes..

has anyone been able to get the reat wiper to idle so that it is verticly center on the rear screen.

im guessing that a realy wud be needed or replaced to get it to work correctly then idle in the centre.

has anyone done this befor??

Cheers in advanced
Adam
 
I've not seen inside a Bravo wiper motor, but...

There is usually a circuit track inside the motor/gearbox that keeps the power on, after the switch is off, until the motor parks. You have to break this in the middle and extend it at the bottom position.

But then again I may be talking bull ;)
 
Howdy

I managed to get mine parked in the centre


mini-08150030.JPG


However, this was a complete fluke. As you probably know the rear wiper motors are renowned for breaking. It just stopped one day in mid sweep and hasnt worked since. Luckily it parked where it did rather than a 45 deg angle :)
 
I think i might just take mine off and silican seal a grommet in its place, i just pisses me off when i am cleaning it anyway
 
Back
Top