Punto (Mk2/2b) punto mk2 blue dash lights

[9UN70Active]

Thanx for da reply dude!!

Oh really wish there wasnt any soldering involved, as my previous car had pop in/out light system!!!

I got completely blue interior with blue door, steering & seat covers, blue foot well LEDs, blue multi media player lights and some blueish extreior too like head and side lights, they look swell, all that's needed is blue dash and demister controls, so I was hoping to change them to make it look a prper mod but it does sound abit complicated since I havent got any soldering experience, but Im willing to give it a go anyway, I'll see what happens. I'll either make it or break it! wish me luck!!

And thnx agen for da reply!!

 

[bazery]

I'm gonna have a go off this, just one or two questions, before i start do i disconnect the battery, and should I not touch the ignition to prevent the airbag warning light. I want to do this but don't want silly warning lights forever more.

 

[Azzam]

i have just changed my LED's in my top half of center console to white, it looks amazing! i am going to change the heater controls white also but i am not sure what to do, i read earlier that if i take the console off again, there is a orange filter,
on the back of my console are some plastic white rings......
how do i take them out? is the filter behind that?
ifnot, when where are the orange filters?

 

[Deekstar]

you take the dash out and if you look on the back there white plastic, remove this and you will get to the dials themselves you need to remove the orange pait on the back of these, its a nightmare though.

 

[CJBate]

I havent tried changing the bulbs. What i did was i bought a plasma dial kit off ebay, it comes as a skin which you slide over the needles, then just gotta find a live and neutral, which i did straight from the fusebox, will try getting a pic up

 

[CJBate]

In regards to the needles, and needing a full tank of fuel. Its all a load of rubbish. i recently upgraded my dials to plasma ones, (got them off ebay). i unscrewed the dial suround 4 small allen headed screws, then theres 3 more bolts actually holding the dial in, undo them and the dials are out, unplug the cable. After you unplug the cable you can turn the needles as much as you like as they are not powered. as soon as i plugged mine back in, needles all over the place, they all hit zero, except the fuel obviosly.

Hope this helps

 

[CJBate]

i got my plasma dials off ebay, they,re okay to fit if you dont mind a bit off cutting and perservering to get the cable through,
--------Take A Look---------
http://www.facebook.com/#!/photo.php?fbid=2024451494697&set=t.1346296046&type=1&theater

 

[CJBate]

here are my plasma dials, got them off ebay

 

[Hottwire]

here are my plasma dials, got them off ebay

Those look sweet mate, want to do same to my car. Just don't want to break anything :\