I so want one of those ramps - which one is it?
Bought them years ago so didn't pay this much for them, but this where I got them from.
http://sm-t.co.uk/product/clifton-3-ton-lift/
As for the handling improvement, not sure yet. The job took a little longer then I expected as the rear springs which should just drop out once you remove the lower damper bolts didn't. The springs are so long the rear beam which goes over the diff hits on the diff before the springs are fully extended so they were sit under compression making it difficult to get them out. I had to use spring compressors to get them out. So by the time I got all of this done it was beer o'clock so never got to go out on a long run, I'll try it today.
If anybody else is thinking of doing this, make sure you remove the plastic lower bump stop on the beam axle, as if you don't there wont be any clearance between the top bump stop and the lower spring seat.
Measurements before, from the wheel centre to the top of the wheel arch - F 385mm R 410mm, now 345mm all round.
Last edited: