Bigvtwin996
Established member
- Joined
- Jul 19, 2011
- Messages
- 1,350
- Points
- 432
Whilst sorting through my ubiquitous tat to offload ... I mean pass on to some worthy cause....
I came across the following.....
The steering wheel fits an Early column....
It's 15" diameter and a 3" dish...
a sort of faux Wood rim...
I assume 126?? or any other suggestions?
Next a speedo...
Purchased because it is clearly a Prototpi MPH one...
However look at the casing it is in....
This is not some modified 500 casing but two separate pieces...
the Cream part is a more flexible plastic than the normal 500 Hard brittle plastic....
I cannot find what it is actually from but being MPH it would have been obviously a MPH country... I brought this in the UK....
Ohh and the profile of the dash side cutout of the housing is a different to a 500 dash..
Ideas??
I came across the following.....
The steering wheel fits an Early column....
It's 15" diameter and a 3" dish...
a sort of faux Wood rim...
I assume 126?? or any other suggestions?
Next a speedo...
Purchased because it is clearly a Prototpi MPH one...
However look at the casing it is in....
This is not some modified 500 casing but two separate pieces...
the Cream part is a more flexible plastic than the normal 500 Hard brittle plastic....
I cannot find what it is actually from but being MPH it would have been obviously a MPH country... I brought this in the UK....
Ohh and the profile of the dash side cutout of the housing is a different to a 500 dash..
Ideas??
Last edited: