ok power point on the way i have no idea were ill host it thou
maybe the forum should provide space for such things it's so much easier to do
if anyone knows were it can be put ill email it
at a garage any more than 250 is getting over expensive
the gaskets and thermostat cost about just under 100
a head skim is 35 quid were i live
takes me 20 minutes to get the head off
and half hour to put it back
for beginners should take about 4 to 5 hours tops i would think
i think i need to take a few more pictures of the timing marks inside the bell housing as that's what i was using as i have a new belt on anyway so didn't take off the bottom puley just left the belt half in place so no chance of seing the marks on the pulley end of the crank not that i ever use them anyway other end is much more acurate and easy to sight
maybe the forum should provide space for such things it's so much easier to do
if anyone knows were it can be put ill email it
at a garage any more than 250 is getting over expensive
the gaskets and thermostat cost about just under 100
a head skim is 35 quid were i live
takes me 20 minutes to get the head off
and half hour to put it back
for beginners should take about 4 to 5 hours tops i would think
i think i need to take a few more pictures of the timing marks inside the bell housing as that's what i was using as i have a new belt on anyway so didn't take off the bottom puley just left the belt half in place so no chance of seing the marks on the pulley end of the crank not that i ever use them anyway other end is much more acurate and easy to sight
Last edited: