Evening. Have suffered from poor master cylinder seals for a bit too long now, so have been replacing the cylinder today. Almost done, but can't get the reservoir into the master cylinder. Should be a push fit of course. As far as I can tell, the rubber gromits are the same size as the old ones. If I extract one from the cylinder, it pops over an outlet on the reservoir easily enough. Any tricks anyone can advise me with? Any more pushing and the plastic will probably give way.
I should say that the cylinder is the more modern replacement item with all the outlets on the top, so has required bending of pipes to fit.
I should say that the cylinder is the more modern replacement item with all the outlets on the top, so has required bending of pipes to fit.