Technical Boot solenoid wiring

[Motordoctor]

Wiring Diagram wanted for central door lock 2010 panda for boot, its got 3 wires just want to know where they go to, im powering it up from an after market alarm


Thanks

 

[Wee Smurf]

Just a word of warning. The onboard computer doesn't exactly like some of the aftermarket alarms. Make sure it's compatible or it'll be going off all the time for simple things (e.g. Light switch left at on, etc). There's difficulty with door recognition too.

 

[Most Easterly Pandas]

Wiring Diagram wanted for central door lock 2010 panda for boot, its got 3 wires just want to know where they go to, im powering it up from an after market alarm


Thanks

The car operates on a CANbus system, you need to fit a CANbus enabled alarm only!

 

[Motordoctor]

Hi guys im not actually breaking into the wiring all im using the alarm for is to power door locks, it will have a power and an earth only, ive fitted a factory boot lock with solenoid attached and a drivers door lock with solenoid attached,when button pressed on fob it will power drivers door solenoid instead of key and all locks will go down, boot is on a boot release switch on dash, im trying to find out why there is 3 wires on boot solenoid, im presuming there is a power and an earth and one extra for feed from a release button , the can bus system is not wired into cdl so fiat dealers tell me, but im not breaking into system anyway so that wont matter, justb looking for wiring diagram

 

[Most Easterly Pandas]

I can assure you the dealer is wrong and it's all canbus controlled. 3rd wire is feed for boot light.