unfortunately they are both a tad under £250
Excellent find!
The only difference between the 100HP and the other model's rear beam is the brakes and they specify both will fit so I don't see any problem [emoji106]
Looks like someone has finally found the difference and made them universal
Looks like axles for drum brakes have a large lip on the stub axle plate but the disc version doesnt
interesting that this axle doesn't have the lip
https://www.ebay.co.uk/itm/New-Fiat...2349624.m46890.l49286&mkrid=710-127635-2958-0
On the thread jrk linked to earlier: https://www.fiatforum.com/panda/486081-100hp-rear-axle-beam-rot.html?p=4585782
As I understand, it was confirmed the drum braked 169 Panda axle is the same width between stub axle plates as the 100HP, and that the stub axle mounting holes are the same (I don't know if OP @MarkPed went ahead with a replacement axle, or if they're still active on here?)
If that's the case, the only differences would be: 1. the top lip on the stub axle plate; and 2. the position of the hole for the ABS wire - looks like those universal axles found by koalar & MD 100hp above should solve that?
It would be nice to get to the bottom of this; finding a source for a rear beam for the 100HP which will either fit out of the box or with simple modifcations could save quite a few of these cars from being scrapped.
This is bad advice; the 500 axle is wider and increases the track by 50mm; whilst you can get away with this on a standard 169, the wider wheel & tyre combination on the 100HP won't clear the arches if you fit a 500 beam, so on the 100HP, it won't work at all.Just fit a 500 axle, you need to cut a slot for the ABS sensor but other than that, they do fit. There is another thread on here going through it all. have a search