Technical Panda 100hp engine mounts

[Lopes3d]

Hi,

I’ve ordered a set of engine mounts (LH side, lower stabiliser mount and gearbox mount) but I can’t find anywhere the torque settings of these, anyone have them or know where to get them?

Thanks James

 

[koalar]

Home Page

aftersales.fiat.com

 

[Lopes3d]

Home Page

aftersales.fiat.com

Thanks, appreciate it

 

[Lopes3d]

Home Page

aftersales.fiat.com

I’ve just had a good look through it, and I’m not sure what the torque spec is when it says for example “ value 5.4 divided by 6.6” any light on this?

 

[koalar]

I’ve just had a good look through it, and I’m not sure what the torque spec is when it says for example “ value 5.4 divided by 6.6” any light on this?

Divide is used to means between

Between 54nm and 66nm

No idea what the minus means it is explained somewhere, but I have forgotten