I'm reading up on preparing and punto 75 1.2 8v engine for turboing.
Now I know I can use 12. 16v piston rods to lower the compression.
But these are hard to find.
I had a crazy thought and would like to know how you guy's think about this.
The 1.2 engine is higher that the 1.1 engine.
So why not use the 1.1 engine rods. Or would this lower the compression to far?
If so maybe it's an idea to CNC the deck until the compression is at the right level?
Now I know I can use 12. 16v piston rods to lower the compression.
But these are hard to find.
I had a crazy thought and would like to know how you guy's think about this.
The 1.2 engine is higher that the 1.1 engine.
So why not use the 1.1 engine rods. Or would this lower the compression to far?
If so maybe it's an idea to CNC the deck until the compression is at the right level?