Guides by Alan.D

I will eventually get round to doing another guide for this but meantime the guide is available here...... https://www.fiatforum.com/panda-classic/51240-heater-matrix-repair-replacement.html

Another very quick but important job. Tools required:- Grease gun filled with grease Can't be easier.... Locate the grease nipple on the UJ and attatch the grease gun. Pump grease into the UJ till you see it comming out of the joints Job done.

This job is directed to those Panda's that have non-adjustable handbrake shoes. If your panda has adjustable shoes they should be adjusted in the first instance. It couldn't be much simpler Time taken less than 5 min. Tools required 2 x 13mm spanners. Same rules apply when under a car ALWAYS...

Tools for this little Job are quite limited but if like myself you have to do it without a lift a blow torch is essential. Anyway you will require:- 10mm Spanner or socket 13mm Spanner or long reach socket Rubber Mallet Blow Torch Pair of grips Slippery compound of sorts I used copperslip.

OK first of all this is a guide, it's how I did the Job. If you have the misfortune of damaging your car, I take no responsibility. I take no responsibility for your lack of safety. :) Right park the car on a flat solid surface put it in first or reverse after turning the engine off, chalk the...

Tools required for this are:- 17mm Spanner or Socket. One pair mole grips. Plumbers type Spanner. Ball Joint seperator. Hammer (just helps :D) Also a little grease required either standard or copper slip.

If you find your gear stick sloppy and has lots of movement even whilst in gear the selector bushes are probably loose and tired. There are many different bushes to replace but for now will stick to the selector levers. The bush is a soft polyurethane that over time expands and as a result the...

It will make no difference whether the panda is 2 or 4wd for this procedure. Tools Required:- Torque wrench 32,19,17,13 & long 12mm sockets 19,17,13mm Ring spaners Good quality ball joint removal tool (This is optional as there are two methods of removing the bearing this procedure does not...