Hi,

For unknown reasons by air intake pipe (I think?) has become loose and makes an annoying vibrating sound. I tried some glue but it didn't stick. My guess it melted away from the heat. How can I reattach this?

GP 1.4 Active Sport

1 tire up and you're done.

I just used a couple of cable ties, worked fine

Same here cable tied mine first week got car (replaced the mount thinking was that nortthe pipe). Cheaper than new pipe (easier to find as well, less go to fiat dealer :-()

Mine kept coming out to, after 4 times of putting it back in it's stayed there for a few months now. Touch wood..

A cable tie did it for me too! Push the rubber stud through the hole and then while someone pushes on the intake hose, put a cable tie round the stud on the FAR side of the mounting plate from the hose and then let go. It should hold it tight against the plate.

Mine's cable tied too though you can get a replacement bracket for a tenner: http://www.ebay.co.uk/itm/231426587260?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT