OP
OP
quick q for the turbo owners oil feed from pump for turbo is the top hole isnt it?
General Whileys Cinquecento Story.. 56k warning.
- Thread starter Whiley
- Start date
Currently reading:
General Whileys Cinquecento Story.. 56k warning.
mine was top, think they varied though 
OP
OP
bottom is pre filter and top is after i think just need someone to clarify it lol
That sounds right from memory
cant remember answer is on my seicento project thread when tricker gave me a roasting about it being wrong lol
- Joined
- Feb 16, 2005
- Messages
- 5,983
- Points
- 988
I can check tomorrow night, as I have an oil pump sitting about. If you look at it of the car, it's obvious.
The filters have a non return flap, so oil will only flow one way, by looking at the pump, and seeing which way the oil filter flows, you can figure it out properly.
I seen setus both ways around and a bit of confusion, so if you wna tme to double check just shout
i think its top one as well though
Kristian
The filters have a non return flap, so oil will only flow one way, by looking at the pump, and seeing which way the oil filter flows, you can figure it out properly.
I seen setus both ways around and a bit of confusion, so if you wna tme to double check just shout
i think its top one as well though
Kristian
was top on the old cinq, dunno about the sei tbh though.
- Joined
- Feb 16, 2005
- Messages
- 5,983
- Points
- 988
cinq, sei, fire, super fire, spi, mpi, 1008, 1242, 1368, it's all the same
1008.......that new to me
i'm guessing you went and did some on this today after i spoke to you then haha
OP
OP
yeh i keep doing little bits, then get angry at it as i cant find bits being a lazy tard tho shouldve been back in and done by now!
being a lazy tard tho shouldve been back in and done by now!
yeh i keep doing little bits, then get angry at it as i cant find bits
haha fair, chopchop then
how far you got? or even how much further you got to go?
OP
OP
lots to do nuff said
i belive someones slacking
ner ner
ner ner
he was moaning to me last night that he couldnt get the timing done as tensioner kept pulling the crank pulley out might take a look for him tonight if he hasnt pulled his finger out already lol
might take a look for him tonight if he hasnt pulled his finger out already lol
no not using decomp plate? shouldnt put the timing out it should all stay spot on unlike when it has decomp then its out by half tooth but doesnt affect it much
Nah i know what it is, it'll be too much slack on the side not being taken up by the tensioner i had the prob before i had my decomp plate
check the teeth on the water pump matey they could be the wrong offset ones of the MPI
Don't think he's mpi mate, so wouldn't make difference surely lol....I'm gussing thats what you ment anyways haha
