- Joined
- Feb 16, 2005
- Messages
- 5,983
- Points
- 988
I run studs and wobbly nuts are rare, especially in 1.25 thread, and locking wheel nuts are even not about afaik.
Has anyone ever considered reboring the cento hub to 100 pcd?? It looks close to the edge but it may be do-able. Then you could use any 100pcd with studs and even go for a 1.5 thread as it seems more common.
A good plan or madness?
I know the centre bore would be off, but isn't that normal with after markets anyway? Spigot rings?
Alternatively are there any hubs in the fiat range that are 100 pcd or a bit meatier to allow for reboring.....i think the new fiats are 100pcd aren't they (got that idea from the oz racing wheel selector)
Kristian
Has anyone ever considered reboring the cento hub to 100 pcd?? It looks close to the edge but it may be do-able. Then you could use any 100pcd with studs and even go for a 1.5 thread as it seems more common.
A good plan or madness?
I know the centre bore would be off, but isn't that normal with after markets anyway? Spigot rings?
Alternatively are there any hubs in the fiat range that are 100 pcd or a bit meatier to allow for reboring.....i think the new fiats are 100pcd aren't they (got that idea from the oz racing wheel selector)
Kristian