General Twin layer boot in my Panda Lounge

[barlicker]

After having a twin layer boot in a previous car I decided to fit a very simple one to my Panda Lounge.I have a spare wheel fitted so used the space around the surrounding area to place items which I find essential (air pump, first aid kit, spare lightweight waterproofs etc.) to form an even layer. I then cut an old piece of twin wall polycarbonate sheet to fit the boot area (anything reasonably rigid will do) and replaced the boot liner on top of it.
This provides me with totally clear boot area and I only loose about 3"-7.5cm and the polysheeting provides a nice firm base to the boot under the carpet.
Recently I have carried several concrete paving slabs plus 3 bags of sand in the boot without any problem.
This modification does not hinder my access to spare wheel etc .in any way.

 

[Ceidio]

Photos?

 

[smittict]

If it isn't too much of an imposition, some pics would be great.


1.2 - are you mad?

 

[aussiepanda]

Recently I have carried several concrete paving slabs plus 3 bags of sand in the boot without any problem.

Steering must've been horribly light, not to mention traction

 

[barlicker]

As you can see from these poor photos the modification is simple.
Pic 1 shows typical items placed on top and around spare wheel .
Pic 2 shows the polycarbonate sheet cut to size
Pic 3 shows the sheet in place.
Them I refit the original boot liner ontop of the poly sheet, leaving me a clear boot without sacrificing much boot height at all.

First lot of pics I have downloaded so hope it works.