Heater matrix and valve replaced!! job done!, the heater valve i needed is no longer available from fiat, so i had to buy a brand new matrix inc valve from ebay (for a tenner!!) then spent half the day removing and refitting the centre console, upside down bent in half shuffling a pack of cards with one hand and peeling an orange with the other (all ad libs from on here) bit tricky! nuckle scrapey! but all went well, even tho i left all my best tools at work, having the right tools makes the job a whole lot easier! leak tested and re-antifreezed ready for the great FREEZE!! the valve i glued last week had'nt leaked since, so maybe anyone in the future could glue theirs although the heat control arm on the valve was weeping a little, so i swapped the lot, and the heat coming into the cabin has improved. so the misses will be happy! he he!! list of tools!! Fine technical screwdriver, (for removing screw covers and grub screws that hold heater control cables) philips screwdriver, 1 stubby, 3 sizes ( magnetic if poss) 1/4 drive socket set (6mm 7mm 8mm 10mm) with various extensions and screw driver attachment, 10mm +8mm spanners, long nose pliers, Oh! and a good light! handlamp type! i used the fluoresent tube, all in all, under 30 screws, just time consuming! started att 11am'ish stopped for few quicky breaks, finished at 4'ish not to bad, and was on the sauce last night! lol! you know me heres a few pics, one of the trickiest screws was the one that holds the front console the the heater box, which required the dash to be removed, so i melted a hole on the inside of the glovebox, with soldering iron, to remove and refit, "Antsuno2"