Rev RPM Signal

[TurboCinqy1250]

Rev RPM Signal Cinq Sporting?

Hi,

I'm busy with a Cinq Sporting project and I need to conect a RPM signal on a gauge unit
(zeitronix ZT-2) www.zeitronix.com.

But Wich wire do I Need to connect. I Think pin 28 of 11 from the ECU or can I Get it from insite of the car.

Also I need A Throttle Position Signal.

Greetzz Dennis

 

[TurboCinqy1250]

Nobody?

 

[HP]

There's a signal wire to the rev counter, you should be able to pick it up behind the cluster, or pin 23 of the ecu? Throttle position signal you'll have to tee off the sensor itself from the pink wire.

Afraid both wiring diagrams I have are a little bit poo.

 

[TurboCinqy1250]

Uhmm pin 23 is the wire that goes tot the Rev Counter on the Dash. The manual is in the garage at the moment

 

[TurboCinqy1250]

There was already a extra wire on pin 23 for my fuelcomputer I did found out yesterday. This is also the wire that goes to my internal Rev counter

The TPS was pin 30

I hope it will work.

Thankx

 

[HP]

Let us know how you get on, should be good

 

[TurboCinqy1250]

Today i put the laptop in my car an sinse yesterday I could let run the engine.

So I could test the laptop system and....We have a RPM and Throttle signal

Pin 23 for Rev and pin 30 for TPS

Blue is RPM and Purple Throttle Position Sensor

 

[HP]

looking good

What's the other signals?

 

[TurboCinqy1250]

Red = Lambda in Volt (Wideband)
Green = Air Fuel Ratio Mixture
Blue = RPM
White = Boost/Vacuum in PSI
Yellow = EGT Exhaust Gas Temperature
Purple = TPS Throttle Pos Sensor
Lightgreen= Extra Free Choice Signal (Not Connected)

 

[HP]

wow, majorly impressed! Good work fella!

 

[TurboCinqy1250]

Here A pic of my engine project

1250cc High Pressure Turbo around 0.8 and maybe 1 bar boost If everything wil work after 600miles Than I can put some boost on the engine