Are you sure it is the relay, if it is trying to move?
I often find a good oiling of the window channels takes the load off the motor and they work a lot better. It nneds to be done regularly.
When servicing customer cars in the past I always oiled the window channels along with door locks and hinges.
These days most garages just seem to give a quick squirt of spray grease to the door hinges if you are lucky.
Are you sure it is the relay, if it is trying to move?
I often find a good oiling of the window channels takes the load off the motor and they work a lot better. It nneds to be done regularly.
When servicing customer cars in the past I always oiled the window channels along with door locks and hinges.
These days most garages just seem to give a quick squirt of spray grease to the door hinges if you are lucky.
I agree. I use silicon spray and just did Pandabird4. Dirt collects on the glass edges and slows things right down over a few years. The actual regulator change is a diy job. Fiddly but straight forward. Take lots of photos as you go so you know what goes where on reassembly. I hadboth front replaced on tge Panda 100 under warranty. Less than 1hr a side by dealer. It was done while I waited.