Technical P0236 came up on 500x 1.4

[Scanny2]

Fiat 500x 1.4 multi air the engine light came on so I plugged in my obd reader and p0236 came up saying boost sensor a circuit range , would I be right that’s map sensor if so where is it thanks

 

[s130]

500X 1.4 Turbo MultiAir Air leakage In turbocharger (Signal compare failure) P0236-00

Component Concerned = Air Intake Pressure Sensor

Connect the diagnosis equipment to the Powertrain Control Module and check that the value of the "intake pressure" parameter is 300 mbar with engine warmed up

Check for the presence of penetration/leaks in the intake manifold

Check the correct position of the throttle body on the intake manifold

Check that the operation of the intake pressure sensor is correct.

 

[Scanny2]

Ok cheers I’ll connect my obd pretty sure it has live data ,how can I tell the throttle body or intake pressure is not set correct

 

[s130]

Ok cheers I’ll connect my obd pretty sure it has live data ,how can I tell the throttle body or intake pressure is not set correct

Not sure. Didn't dig any deeper and have not had to mess with modern throttle bodies.

 

[Xenotime]

Hi. I replaced all the suspicious items. N75, wastegate actuator, turbo, map sensors… P0236 is there.
Jose’s to throttle body and intercooler have been visually checked. Below you can see values I am getting at idle and warm engine. Symptoms are boost not more than 0.7bars and cruise control that goes away till next restart if the engine. Also this is happening mostly when I am pushing the car with a higher gear than I should. Please help..