donovan2123
New member
- Joined
- Nov 9, 2006
- Messages
- 67
- Points
- 20
Ok i have been trying to bleed my car for a couple of weeks and i have had no luck i hae changed thermostat twice but nothing. My problem is when i start from cold evertything is good heater is on and temp gauge is reading normal then after about 10 mins temp rises and hot air in car goes cold. So the fix i have to do when this happens is re-bleed system and then its fine intill car is left not running for about 3/4hours and then same problem. I i have recently banged a universal air filter which i fitted direct on to the carb and im wondering if this is what is causeing air to get in to the water system. cause when i do the blled i get pure water while everything is running i have even left 1 bleed screw half open with light revs to get air out but nothing just get water. Also on original air filter there are 2 small air pipes 1 is brown and 1 is black i do not have a haynes manual but i would like to know where they attatch to on air fiter as there are 2 holes for them bu ti dont no which way round they go e.g if brown 1 which comes from carb goes to the smaller hole on the air filter. Someone please help me