recently had an ecu issue causing car to not run. replaced the ecu and now the car starts and runs fine but i am having issues with the dashboard display.
issues-
so i noticed the clocks dont activate when you open the door. im sure they used to show the time / mileage.
When you turn the ignition key, the speedo and rev counter flicker for a couple of seconds and then the clocks light up. few seconds later im getting airbag failure warming displayed.
then it decided to start displaying everything in spanish and KMh. changed the language and units back to english and mph, but once you turn the key off and on it went back to spanish :bang: only way to stop it was to disconnect ecu / battery and reconnect. still getting the issues above though.
its had a recent battery and have ran it through a full charging cycle, but made not difference.
Plugged my MES diagnostic cable in and now it wont see the interface. :bang: i have connected my hand held scanner and its not getting power from the obd2 socket.
any ideas?
issues-
so i noticed the clocks dont activate when you open the door. im sure they used to show the time / mileage.
When you turn the ignition key, the speedo and rev counter flicker for a couple of seconds and then the clocks light up. few seconds later im getting airbag failure warming displayed.
then it decided to start displaying everything in spanish and KMh. changed the language and units back to english and mph, but once you turn the key off and on it went back to spanish :bang: only way to stop it was to disconnect ecu / battery and reconnect. still getting the issues above though.
its had a recent battery and have ran it through a full charging cycle, but made not difference.
Plugged my MES diagnostic cable in and now it wont see the interface. :bang: i have connected my hand held scanner and its not getting power from the obd2 socket.
any ideas?