Asteris
Member
I want to fit a fuel pressure gauge in the dashboard. I already have an oil pessure gauge, so i only got a sender and will use a rocker switch to alternate the readings.
Sender is an 1/8" NPT type
My motor is a 1.2 75ps mpi (Punto75), so it uses the 4 injector rail, with the fuel hose using a threaded fitting on the end.
I found this on ebay
http://cgi.ebay.co.uk/8-AN8-Male-Female-Union-1-8-NPT-Side-Port-/150606505649?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item2310d8e6b1
that i think simplifies the connection. It is an An -8 male to female, with 1/8 NPT side port. Is this the correct female thread for the injection rail?
Sender is an 1/8" NPT type
My motor is a 1.2 75ps mpi (Punto75), so it uses the 4 injector rail, with the fuel hose using a threaded fitting on the end.
I found this on ebay
http://cgi.ebay.co.uk/8-AN8-Male-Female-Union-1-8-NPT-Side-Port-/150606505649?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item2310d8e6b1
that i think simplifies the connection. It is an An -8 male to female, with 1/8 NPT side port. Is this the correct female thread for the injection rail?
This post contains affiliate links which may earn a commission at no additional cost to you.