Technical Engine cuts out

[lycopersicum]

It's for the 40 / 60 seconds its running, i will take time today to check against another car in the household.
I've reset to imperial psiView attachment 470766

That's just the same 655350 value converted to psi. You are not seeing any real data here, just an error turned into a meaningless straight line

 

[Keith1950]

That's just the same 655350 value converted to psi. You are not seeing any real data here, just an error turned into a meaningless straight line

I know thst but that is what came back. Doesn't really answer my question though

 

[jackwhoo]

A scan tool may read correctly on one make and model of vehicle but that does not mean it will read a different vehicle correctly.

I think @lycopersicum has attempted to answer one of your questions fully with good grace.

 

[diego74]

Sorry if I missed it, but what vehicle and engine are you having issues with?.

2.8JTD uses 275/300 bar in high pressure fuel lines, so if you are overpassing that value the ECU will stop the engine. The same happens if the low pressure fuel pump performance decreases due to a problem on it, this can be diagnoses with a fuel pump gauge connected to the fuel line and it should be around 4/5 bars.

 

[Keith1950]

Sorry if I missed it, but what vehicle and engine are you having issues with?.

2.8JTD uses 275/300 bar in high pressure fuel lines, so if you are overpassing that value the ECU will stop the engine. The same happens if the low pressure fuel pump performance decreases due to a problem on it, this can be diagnoses with a fuel pump gauge connected to the fuel line and it should be around 4/5 bars.

Thanks for the reply much appriciatef