Technical drivers side wheels bent inwards

[ashtonharley]

crashed into a kerb at roughly 45-50 mph and managed to drag the car over it into a hedge and now the top of the drivers front and rear wheels are pointing inwards towards the car.

I know it'l more than likely need a new bottom arm on the front along with the possibility of a new hub and trackrod ends but what could be bent on the rear ?

some people seem to think it could be the axle, some say springs and some say bushes and then others say bearings.


any ideas ?

 

[Most Easterly Pandas]

Rear will be USed and damaged axle, possibly even worse the subframe (axle) mounting points. Sounds like its a write off unfortunately

 

[XB23]

Is it insured? Just claim sounds like youve got major damage there

 

[ashtonharley]

Rear will be USed and damaged axle, possibly even worse the subframe (axle) mounting points. Sounds like its a write off unfortunately

Is it insured? Just claim sounds like youve got major damage there

managed to fix it, front drivers side camber was reading +2.45, managed to get it down to +1 (just within tolerance) by elongating the holes in the strut where the hub attaches to.

as for the rear, the cambers only +1.25 so it's not that badly damaged although it will rip any tyre i put on it to shreds