Damsel In Distress Needs Help With Panda!!1

[`Manda Panda]

(COLOR=Magenta)xxx(/COLOR)
Hi everyone I am new to this site been reading and you all have much faster sportier models that me!!! I just bought a 1994 Panda and I was wondering if anyone can tell me how to bleed the bloody radiator the cooling system doesn`t seem to work as the heater blows cold and the engine temp goes high bloody damn quick although doesn`t go into the red......yet!!! Its the fuel injection model a 1000 M reg. The Haynes manual sems to show a different model with a radiator with a cap on the top and mine simply doesn`t have that. Any ideas??? Any help gladly welcomed or ideas on how to sort this? Apart from that shes ok. Does anyone know how much a reav cv joint is to replace on this model.
Bye
`Manda Panda
xxx
:bang:

 

[`Manda Panda]

Don`t ask me what that Magenta color malarky is all about!!!
`Manda Panda

 

[Liam]

No worries over the colours!

No experience with Pandas but I'm sure there is a bleed screw somewhere to help you bleed the car, someone will advise soon no doubt.

Welcome to the forum!

Liam

 

[`Manda Panda]

Thanks Liam I will await with baited breath.
`Manda Panda

 

[joecinq]

welcome to the forum

sounds like bleeding the system will help...just find that screw

nice title btw

 

[`Manda Panda]

How can I doenload a photo next to my user name of my faithfull yet hot and thirsty at the moment Panda.
`Manda Panda
X

 

[joecinq]

You need to resize the picture that you have of you car (80 by 80 pixels or 19.5 KB)

Then go to 'user CP' (top left of page) and then click on 'edit avator' ... then its just a matter of uploading your picture

 

[warrmr]

i couldent tell you where the bleed screw is. but what you could do is find the lowest point of the coolant system ( bottom of the rad or expantion tank.) and undo the jubalie clip holding the pipe on and remove that as it will do the same job. you will also need to remove the rad cap.