Seicento custom gauges

[B3CK377]

Hello, im unsure if im in the right section but here goes.
Ive bought some custom gauges (water temp and volts). I also bought a twin gauge holder for the dash. I dont want ro cut the dash so how would i go about trimming the holders to match the profile of the dash?

 

[fingers99]

No idea. One way of mounting them is in the central air vent (pops out). The real trick on the Sei is getting the angle right so the guages don't face the roof!

 

[B3CK377]

No idea. One way of mounting them is in the central air vent (pops out). The real trick on the Sei is getting the angle right so the guages don't face the roof!

Ive got a dual 52mm pod holder. I just need tips on how to cut the pod so it fits the shape of the dash

 

[Eklipze3k]

Hi Beckett, welcome to the forum

A craft knife and a small file probably going to be the only way, just be careful not to trim it so much that the gauges foul and negate all your hardwork! Whereabouts on the top of the dash do you plan to put them?

 

[fingers99]

Ive got a dual 52mm pod holder. I just need tips on how to cut the pod so it fits the shape of the dash

Yes, but they tend to look pants, especially when you've already got the -- completely different shape -- tach pod on there. WTH, it's your car.

 

[B3CK377]

Hi Beckett, welcome to the forum

A craft knife and a small file probably going to be the only way, just be careful not to trim it so much that the gauges foul and negate all your hardwork! Whereabouts on the top of the dash do you plan to put them?

Hello and thankyou. Ill be mounting rhem centrally like where the sporting dials sit. Probably a tad further back. They are a really nice pair of blue lcd which has a glass black finish wen they are off

 

[B3CK377]

i dont have the tach pod. Its only a 1.1 active