And some more
Instructions update patch 5.4 Sony Ericsson - Ver 1.0
INSTALLATION INSTRUCTIONS FOR PATCH FOR THE CONNECTION
PHONES WITH SONY ERICSSON
WARNING The update only works with Blue & Me ™ version
5.4.
If your car has recently production could already be updated, installed in doubt
however the upgrade to version 5.4, in which case the procedure will last a few seconds.
The upgrade process is an operation to be executed following very closely the
instructions. In case of errors the system could no longer work.
1. From the official site
www.fiat.it FGA access the section of Blue & Me ™ and downloads
the. zip file contains the application update.
2nd Unpack the. Zip file downloaded in a suitable directory (eg c: \ Blue & Me).
After verifying that the following files:
• install.inf
• Patch_5.4_for_Sony_Ericsson.CAB
• R_Patch.CAB
3rd Preparing a USB memory stick, with a capacity of 128 Mb, format the
FAT32 mode memory to erase all data previously contained.
NOTE It is recommended to use USB memory with less than 8 Gb.
4th Store on the USB stick in the directory (folder) main files previously
downloaded, making sure they were all properly reported
WARNING Before starting the update, you must turn off the phone
cellular
During the software update should not be pressing the buttons on
steering wheel!
5th The car stops and key start-up in STOP position, insert the key to
USB memory into the Blue & Me ™ centrally located on the cabinet door or drawer
objects.
(The update is not available for vehicles not equipped with USB media,
not use the USB diagnostic if present on the controller)
6. Bring the key to starting position MAR WITHOUT START THE CAR,
turn on the radio taking care to remove the display of any messages
signaling (eg door open ...) the display of the scoreboard by pressing the "Mode" or "Menu"
(depending on the car to be updated).
CAUTION Never remove any reason for the memory stick from the USB
before the software update process is completed successfully!
7th The display of the board of the message: "AGG. CURRENT ", and is
play the voice message "update started." Should this not
happen bear the STOP key position and then again in MAR. During
Instructions update patch 5.4 Sony Ericsson - Ver 1.0
the update will appear on the display of some messages about
trial.
8th Upgrade to finish, is displayed on the part of the board
message "DONE" and you play the voice message "update
completed, remove the USB memory. "
9th The process of updating the Blue & Me ™ is completed, bring the key
starting in the position of STOP and remove the USB memory.
If updating is not completed, the display appears the message "USB Error xx" and
will be played the following voice message: "There was an error during the upgrade." In
this case repeat the process by spreading from 1st