Technical 46840510

[Tarzan1123456]

Break pedal switch signal invalid. Anyone had the same problem. Is it that switch that I have to change?

 

[koalar]

Twin air is a 319 panda

This section is for the older 169

Yes it's confusing

Yes its.a.commom.problem
Yes it usually the switch

You can sometimes fix them by gently pulling the plunger out,it's on a ratchet and let it recalibrate, especially if the fault occured after the foot slipped of the pedal and it bounced back hard

 

[Tarzan1123456]

The UK version of the panda twin air .the switch is on the passenger side . It is good to know that. I tried to remove and put it back again but the triangle spy light is still on.

 

[koalar]

Brake lights on permanently! | FIAT Panda (Mk3)

In the position of the plug in the pic I’ve indicated the two pins with battery voltage. Is there a relay somewhere for the brakes?

www.fiatforum.com

Try pulling the little plunger out as here sometimes fixes them

If not it should just be a replacement job

 

[Tarzan1123456]

Brake lights on permanently! | FIAT Panda (Mk3)

In the position of the plug in the pic I’ve indicated the two pins with battery voltage. Is there a relay somewhere for the brakes?

www.fiatforum.com

View attachment 484642

Try pulling the little plunger out as here sometimes fixes them

If not it should just be a replacement job

Good news I replaced it .I bought it in Amazon for 10 pounds and even better the TRIANGLE LIGH WITH THE EXCLAMATION POINT HAS SWITCHED OFF