Technical 2020 Fire Wall pass through

Currently reading:
Technical 2020 Fire Wall pass through

Squeaka

New member
Joined
Aug 23, 2020
Messages
5
Points
3
Hi Folks
Im installing a UHF radio and trying to find the wiring access gromet to pass the aerial coax into the cab. The engine bay is really cramped and not at all user friendly.
Does anyone have an image vid link etc.. on the best way to get the coax into the cab.
Thanks
 
Not done it myself as I put aerials on the roof. But Nick Fisher said they usually run extras out through the existing loom seal above the accelerator.
"Easiest to remove RH headlamp etc, and lwr rt dash pocket fuse cover. Use a test light or sharp screw driver to pierce the gland, feed a draw wire through, solder to other wires and pull it back through. You will probably need to spray silicon, easy glide, or similar on the grommet. Use brazing wire if you can't get auto wire through."
 
Back
Top