D

DRIVE ME CRAZY

New member

Joined

Nov 11, 2011

Messages

50

Points

15

Location

swansea

• Aug 20, 2012

• #1

hi everyone can anyone tell me what size the hub nuts are front,and back so i can buy the appropriate sockets,also the torque settings for them thanks. ( 2004 stilo diesel est)

 

Last edited: Aug 20, 2012

Peat

Grumpy Old Manx Git

Joined

Dec 20, 2005

Messages

758

Points

165

Location

South Leicestershire

• Aug 20, 2012

• #2

Front stub axle nut is 36mm

The rear is 32mm

 

Last edited by a moderator: Dec 5, 2016

OP

OP

D

DRIVE ME CRAZY

New member

Joined

Nov 11, 2011

Messages

50

Points

15

Location

swansea

• Aug 20, 2012

• #3

thanks peat.

 

schumraid

Patron member

Parked in the garage

Joined

Oct 1, 2010

Messages

431

Points

92

Location

Belfast

• Aug 23, 2012

• #4

Can confirm from experience that they are 36mm, the problem is then the size of the bit. Thanks to the design with the nut in the middle of a protruding metal circle, too thick of a bit will not fit, so be careful with that. I ordered a Draper impact bit and it was too thick FYI. I can't remember who made the bit that did eventually fit, sorry

Good luck

 

Shadeyman

Patron member

Written a guide

Joined

Sep 29, 2008

Messages

6,174

Points

1,379

Location

Wolverhampton

• Aug 23, 2012

• #5

I'm 99% sure the front nuts are 36mm on the 3 door, 5 door and Multiwagon.

But the size of the nut on the rear of a 2004 Multiwagon is 32mm, not sure about the 3 and 5 door versions but I'd expect it to be the same.

Here's a couple of photo's of a 2004 Multiwagon rear stub shaft with nut and washers. Popped a 32mm socket on it just to check.

 

Attachments

• 
  2012-08-23-151.jpg

  1.6 MB · Views: 36
• 
  2012-08-23-154.jpg

  1.5 MB · Views: 35
• 
  2012-08-23-153.jpg

  1.1 MB · Views: 32

Last edited: Aug 23, 2012

Peat

Grumpy Old Manx Git

Joined

Dec 20, 2005

Messages

758

Points

165

Location

South Leicestershire

• Aug 23, 2012

• #6

You are absolutely correct in saying the rear hub nut is 32mm.

 

Last edited by a moderator: Dec 5, 2016

OP

OP

D

DRIVE ME CRAZY

New member

Joined

Nov 11, 2011

Messages

50

Points

15

Location

swansea

• Aug 23, 2012

• #7

thanks guys , any idea of the torque settings?

 

schumraid

Patron member

Parked in the garage

Joined

Oct 1, 2010

Messages

431

Points

92

Location

Belfast

• Aug 24, 2012

• #8

According to what I have wrote down and I can't even remember where I got this from lol front is 7daNm + 62 degrees rear is 25 daNm. That's for the 1.6 though, I don't know if the rest are the same...

Edit: don't think I even have a 32mm bit, how did I get my rear off

 

Last edited: Aug 24, 2012