basshunter98
Member
- Joined
- Sep 11, 2019
- Messages
- 11
- Points
- 52
I have a 2005 panda with 188a4000 60hp engine, Euro 4 but still the old head with the squared oil cap. I am a complete beginner from a mechanical point of view.
Although there is zero documentation of this work being done on a Panda 169, I want to install a 1.2 75hp head of the punto mk1. The problem is that from the web i've seen that in between the outer intake holes and the screw holes there is no material, while in our head it is full and leveled of aluminum. Do you by any chance know if I can still install the 60hp plastic intake manifolds on the 1.2 75hp cylinder head despite the differences?
Thank you very much in advance, I will keep you updated in this thread.:bang:
Although there is zero documentation of this work being done on a Panda 169, I want to install a 1.2 75hp head of the punto mk1. The problem is that from the web i've seen that in between the outer intake holes and the screw holes there is no material, while in our head it is full and leveled of aluminum. Do you by any chance know if I can still install the 60hp plastic intake manifolds on the 1.2 75hp cylinder head despite the differences?
Thank you very much in advance, I will keep you updated in this thread.:bang: