Could someone give me any advice, clues or just plain help please. I want to install a dash cam and would like to put the wiring behind the near side A pillar trim on my Panda Easy 2016 model..

The only advice I can find online is to remove such trim by easing away from the body. I have priced a replacement at £27 and would prefer not to have to go down that route so if anyone can help I would appreciate it. I have tried easing it off with a trim tool but the pressure was getting a touch on the high side so I chickened out.

You don't need to remove this panel.

Along the edge of the A pillar trim, door side is a seal.
The lip of this seal will lift up so you can hide the wire behind it.

I just tucked my wire in along the top of the A pillar trim, then down behind the seal, then out just below the glovebox to plumb into the fuse box behind.

Thanks, I will have a look.

I had intended to thank you via an icon,but seem to have thanked myself, apologies.